The rope strap should not be wet or rained and removed as soon as possible. Immediately wipe it with a dry cloth and wring it dry. You can continue to wear it; because the human body has body temperature, the rope strap manufacturer recommends that it must be naturally dried or painted on the strap. Leather oil can protect the rope and better maintain the rope.
The printing mold is a polyester or nylon mesh (pattern) fixed on a square frame and has a hollow pattern. The pattern on the pattern can be passed through the color paste, and the non-patterned place is closed with a polymer film. When printing, the pattern is pressed tightly on the fabric, and the color paste is placed on the pattern, which is scraped back and forth with a scraper to make the color paste reach the fabric surface through the pattern. Flat screen printing has low production efficiency, but has wide adaptability and flexible application, which is suitable for small batch and multi-variety production.
Rope manufacturers
First need two pieces of cloth, draw the width of the elastic band on the upper cloth, and sew the two pieces of cloth along these two lines, insert the elastic band, and then stitch the ends of the cloth to complete. The so-called water slurry is a kind of water-based slurry, which is not strong when printed on clothes, and the covering power is not strong. It is only suitable for printing on light-colored fabrics. The price is relatively low. It is a lower-end printing type.
But it also has an advantage, because it will not affect the original texture of the fabric, it is more suitable for large-area printing patterns. Features soft touch and bright color~~ But the water slurry has a major drawback. The color of water slurry is better than that of cloth. Light color ~ ~ If the cloth color is darker, the water slurry will not cover it at all.
The cloth required must be the width of the elastic band + 2 cm seam allowance. First, half of the cloth is stitched, and then the stitched tube is turned to the front with a pin. After the elastic band is inserted in the first method, the two ends are stitched firmly. It is the last effect. Draw the trajectory of the elastic band that needs to be sewn on the cloth, and then find the middle point of the cloth and elastic band respectively, that is, when the cloth is divided into two equal parts, remember to align the middle points and sew straight lines on the elastic band.
Draw the trajectory of the elastic band to be sewn on the cloth, and sew straight lines directly on the cloth. It is better to sew. When sewing the next few strips, the elastic band should be used this time, but it is used as the bottom thread when winding it on the shuttle Tighten up a bit. When the cord has a sour smell, use a soft toothbrush with a little nasal spray to quickly scrub the dirty area, quickly rinse with water, and use the “pinch and put” method to pinch out the foam. The process Completion within 15 seconds is better; furthermore, use natural air drying method or use a hair dryer 15 cm away (to avoid scorching and deformation of the rope) to complete the rope maintenance.
